Kärcher Winner 207 Manual De Instrucciones página 18

- The plug and the coupling of an extension line must be wa-
terproof.
- Always unwind the extension line completely from the cable
drum.
Connection to the Water Conduit
Please observe the provisions of the local water supply com-
pany.
Only use supply hoses (not included in the delivery) with the
following dimensions:
- minimum length 7.5 m
- minimum diameter ½''
Please see the typeplate or the section "Specifications" for the
connection values.
Operation
!
Danger of life!
Vehicle tyres/tyre valves may be damaged and burst by the
high-pressure jet. A first sign is the discoloration of the tyre.
Damaged vehicle tyres/tyre valves are hazardous. Always
perform the cleaning with a distance of at least 30 cm. Never
touch the mains plug with wet hands. Check the power cord
and the mains plug for damages prior to each use of the ap-
pliance. If the power cord is damaged, please arrange imme-
diately for the exchange by an authorized customer service or
a skilled electrician.
Check the high-pressure hose for damages prior to each use
of the appliance. If the high-pressure hose is damaged, repla-
ce it immediately.
!
Danger of injury!
Due to the water jet emerging from the high-pressure nozzle,
a recoil force acts on the trigger gun. Always ensure a stable
standing position and hold the trigger gun and the spray jet
firmly.
If necessary, wear protective clothes for the protection from
return spray.
Water Supply from the Water Main
• Connect a supply hose (not included in the delivery) to the
water connection of the appliance and to the water supply.
• Open the water supply.
Water Supply from an Open Container
• Unscrew the coupling unit for the water intake.
18 English
• Fasten the suction hose with the filter (not included in the
delivery) with screws on the water connection of the appliance.
• Insert the filter into the container.
• Deaerate the appliance before using it.
• Unscrew the high-pressure line at the high-pressure con-
nector of the appliance.
• Turn on the appliance and let it run until bubble-free water
emerges at the high-pressure connector.
• Turn off the appliance, and fasten the high-pressure hose
with screws.
Preparing the Appliance
• Insert the mains plug.
• Set the main switch to "I".
Turning On the Appliance
• Press the safety button on the trigger gun, and pull the lever.
Turning Off the Appliance
• Release the lever.
Press the safety button to prevent the appliance from being
inadvertently turned on during breaks or if you leave the ap-
pliance.
Regulate operating pressure
Raise operating pressure:
• twist spray lance in direction «
Reduce operating pressure:
• twist spray lance in direction «
Adding the cleaning agent
• Draw the cleaning agent suction hose out of the housing to
the required length.
• Hang the cleaning agent suction hose in the cleaning agent
container.
• Twist the spray lance in the « » direction until the stop.
Note: No detergent in high-pressure mode
If detergent has been added:
• Put the detergent suction hose into a container with clear
water, turn on the appliance for approximately 1 minute, and
perform a clear rinsing.
Recommended Cleaning Method
1.Spray a small dose of the detergent on the dry surface, and
allow it to react (make sure the detergent does not dry up).
2.Wash off the loosened dirt using the high-pressure jet.
Terminating the Operation
• Main switch to "0".
• Disconnect the mains plug.
Water supply from the water main
• Close the water supply tap.
• Pull the lever on the trigger gun until the appliance is unpres-
surized.
• Press the safety button to protect the appliance from being
inadvertently turned on.
• Disconnect the appliance from the water connection.
Water supply from an open container
• Unscrew the suction hose with filter from the water connec-
tion of the appliance.
• Pull the lever on the trigger gun until the appliance is unpres-
surized.
• Press the safety button to protect the appliance from being
inadvertently turned on.
Storing the Appliance
Caution! Frost may destroy the appliance if it has not been
emptied completely. Store the appliance in a frost-free room
during the winter.
• Separate the jet spray lance from the trigger gun.
• Wind up the power cord and, for example, hang it around the
».
handle.
».