For The First Time; Mincing Meat; Reverse Function - Sinbo SHB 3087 Manual De Instrucciones

All manuals and user guides at all-guides.com
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.

FOR THE FIRST TIME

• Check that voltage indicated on the rating label correspond the mains voltage in your
home.
• Wash all parts (except body) in warm soapy water.
• Before plugging in, ensure the "ON/OFF/ REV" switch is turned to "OFF" position.
INSTRUCTION FOR USE
ASSEMBLING
• Holding the head and insert it in the inlet with one hand, place the locking knob into
the hole on the side of the motor housing?tighten it clockwise to secure the head .(fig.2)
• Place the feed screw into the head, long end first, by turning the feed screw slightly
until it is set into the motor housing (fig.3).
• Place the cutting blade onto the feed screw shaft with the blade facing the front as
illustrated (fig.4). If it is not fitted properly, meat will not be ground.
• Place the desired cutting plate next to the cutting blade, fitting protrusions in the slots
(fig.5).
• Support or press the centre of the cutting plate with one finger then screw the fixing
ring until tight with another hand (fig.6). Do not over tighten.
• Place the hopper plate on the head and fix into position.
• Locate the unit on a firm place.
• The air passage at the bottom and the side of the motor housing should be kept free
and not blocked.

MINCING MEAT

• Cut all foods into pieces (Sinewless, boneless and fatless meat is recommended,
approximate size :20 mm x 20 mm x 60 mm) so that they fit easily into the hopper opening.
• Plug in and turn the "ON/OFF/ REV" switch to "ON" position.
• Feed foods into the hopper plate. Use only the food pusher (fig.7).
• After use switch the unit off and unplug it from the power supply.

REVERSE FUNCTION

• In case of jamming switch the appliance off by turning the "ON/OFF/ REV" switch to
"REV" position..
• Feed screw will be rotating in the opposite direction, and the head will get empty.
• If it doesn't work, switch the unit off and clean it.
- 8 -