Publicidad
Idiomas disponibles
Idiomas disponibles
MFT/3-VL
1
Technical data
Bench dimensions
(width x length)
Bench height with
foldaway legs
Weight
2
Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
The specifi ed illustrations are at the beginning of
the Operating Instructions.
3
Intended use
MFT/3-VL is a basic unit for mounting the
-
CMS-TS 55
-
CMS-TS 75
-
CMS-PS 200/PS 300
-
CMS-BS 120
-
CMS-OF
-
Basis modules (except Basis 1A)
in combination with multifunction table MFT/3.
Do not install modules and electric power tools
that are not manufactured by Festool. Installing
other electric power tools may render the bench
unsafe and increase the risk of injury to the user.
Use in combination with the MFT/3 only.
The user bears the responsibility for damage and
accidents caused by improper use.
4
Safety instructions
CAUTION! Read and observe all informa-
tion and safety instructions. Ignoring warn-
ing notes and instructions may lead to elec-
tric shocks, fi res and/or cause serious injury.
The term "electric power tool" used in this docu-
ment refers to all mains-powered (with mains
cable) or battery-powered (without mains cable)
electric power tools.
-
Keep all of the accompanying documents and
pass on the documentation if the machine
changes ownership.
773 x 481 mm
854 mm
11.3 kg
-
Remove the plug from the socket before ad-
justing the machine settings, changing acces-
sory parts or putting away the machine. This
precautionary measure will prevent the ma-
chine from starting accidentally.
-
The bench legs should be locked in position
and secured against folding before the pow-
er tool is installed. Securing and locking the
legs is particularly important on collapsable
benches.
-
Make sure the power tool has been fi tted se-
curely to the bench before using. Power tools
that move within the bench may run out of
control.
-
Position the bench on a stable, level, horizon-
tal surface. If the bench slides or wobbles, it
may not be possible to control the power tool
safely and reliably.
-
Do not overload the bench and never use it as
a ladder or trestle. Overloading or standing
on the bench will make it top-heavy and it will
most likely tip over.
5
Setting up
f
Ensure that the fl oor around the machine is
level, in good condition and free of loose ob-
jects (e.g. chips and offcuts).
f
Unscrew the two rotary knobs [1-1] all the way
and unfold the legs [1-2]. Tighten the rotary
knobs again once the legs are unfolded.
f
Slacken the screws [3-2] if necessary.
f
Position the table extension MFT/3-VL into the
groove on the MFT/3 from above [Fig. 2]. Make
sure that the profi le groove alignment lines on
the MFT/3 and MFT/3-VL [3-4] line up.
f
Adjust the height of the MFT/3-VL to the MFT/3
on both sides using screws [3-1].
f
Lock both sides of the MFT/3-VL using the
screw [3-2] on the MFT/3.
f
If the machine wobbles, turn the end caps
[3-3] on either leg to adjust the length so that
the machine stands securely.
9
Publicidad
