Complete The Installation - Jacob Delafon E8002 Instrucciones

8. Complete the installation

Ribs
Groove
• With the ribs of the sprayhead facing up, attach the sprayhead to the waterway.
• Using a 3/16" hex wrench, secure the sprayhead to the waterway with the two hex
screws provided. Do not overtighten.
• Check the sprayhead for upward and downward movement and that it sits squarely
within the escutcheon.
• Place the nozzle membrane over the sprayhead.
• Align the long edge of the membrane with the hinge ribs (horizontal).
NOTE : For optimum performance, ensure that the membrane is applied evenly.Ap-
plying pressure evenly, press the membrane seal into the sprayhead groove.
NOTE : For product with brushed finishes, align the brush pattern of the sprayfaces
with the direction of the brushed pattern of the escutcheon.
• Tilt the sprayhead downward so the ribs on the top of the sprayhead are exposed.
• Insert the grooves of the sprayface over the ribs of the sprayhead.
• Press the sprayface down to cover the sprayhead, as illustrated.
• Tilt the sprayhead upward to expose the setscrew holes on the
bottom of the sprayhead.
IMPORTANT ! The setscrews must be flush with the edge of the sprayface frame. If
the setscrews protrude outside of the sprayface frame, product damage will occur.
Using a 5/64" hex wrench, turn the setscrews counterclockwise until they are flush with
the edge of the sprayface frame.
20
Attach the sprayhead
Nozzle membrane
Attach the sprayface
Finished wall
Ribs
Sprayface
English
Waterway
Sprayhead
Hex screws
Setscrews