Programme 2 „12 V" (14.4 V / 0.8 A); Programme 3 „12 V" (14.4 V / 3.8 A); Programme 4 „12 V" (14.7 V / 3.8 A); Retention Charge - ULTIMATE SPEED ULGD 3.8 A1 Instrucciones De Utilización Y De Seguridad

is fully charged, the condition display
4 bars. The flashing stops and the appliance
automatically switches to retention charge.
Programme 2
(14.4 V / 0.8 A)
For charging 12 V batteries with a capacity of less
than 14 Ah.
Press the programme selection button
select programme 2. The symbol
played on the LCD. During charging, the charge
display flashes and shows the progress of
7
the charge procedure (1–4 bars). When the
battery is fully charged, the condition display
shows 4 bars. The flashing stops and the appli-
ance automatically switches to retention charge.
Programme 3
(14.4 V / 3.8 A)
For charging 12 V batteries with a capacity of be-
tween 14 Ah–120 Ah.
Press the programme selection button
lect programme 3. The symbol
on the LCD. During charging, the charge dis-
play flashes and shows the progress of the
7
charge procedure (1–4 bars). When the battery
is fully charged, the condition display
4 bars. The flashing stops and the appliance
automatically switches to retention charge.
Programme 4
(14.7 V / 3.8 A)
For charging 12 V batteries with a capacity of be-
tween 14 Ah–120 Ah under cold conditions or for
charging AGM batteries.
Press the programme selection button
select programme 4.
All manuals and user guides at all-guides.com
shows
8
„12 V"
, to
10
is dis- As described under programmes, this appliance
features the automatic retention charge. Depending
on the voltage drop of the battery, caused by
self-discharge, the appliance reacts with different
charge currents.
8
The battery can remain connected to the charger
for longer periods of time.
„12 V"
The charger switches the electronics off and switches
the system instantly to the basic setting, as soon as
there is an abnormal situation, such as short circuit,
critical voltage drop during charging, broken circuit
, to se- or swapped connection of the connector clamps is
10
is displayed detected.
Should the appliance become too hot during charg-
ing, the output current is automatically reduced.
shows This protects the appliance from damage.
8
„12 V"
The appliance is maintenance-free.
, to
10
Operation / Maintenance and care
nOTE: This programme may start with a minute
delay. The symbol is displayed on the LCD.
During charging, the charge display
and shows the progress of the charge procedure
(1–4 bars). When the battery is fully charged,
the condition display
8
flashing stops and the appliance automatically
switches to retention charge.

Retention charge

Appliance protection function

Maintenance and care

Before you carry out any work
on the battery charger always pull the mains
plug out of the mains socket.
D o not under any circum-stances use solvents
or other aggressive cleaning agents.
C lean the plastic surfaces of the device with
a dry cloth.
flashes
7
shows 4 bars. The
GB/MT 33