Detergent Suction - LAVOR Pro Mississippi Manual Del Usuario

EN
fuses, differential security breaker, etc).
In case of failure to comply with one of the
regulations stated above, the manufacturer
declines all responsibility for the staff and
provides no warranty.
IMPORTANT: Regarding three-phase motors,
pay attention to the connection of the elec-
tric cable to the plug (see electric diagram).
FILLING UP WITH FUEL
Fill the tank with the fuel indicated on the tech-
nical data plate (Diesel, ref. 1, pos. 12a).
Avoid that the tank is empty when the machine is
running in order not to damage the fuel pump.
•
Incorrect fuel shall not used as they as
provide hazard.
Fill up the detergent tank with the suggested
products, suitable for the kind of washing to be
carried out (ref. 1, pos. 12b).
•
CAUTION: Make use only of liquid deter-
gent, do not absolutely use acid or too
much alkaline products. We suggest you to
make use of our products, which have been
studied for the use with washer machines.
START-UP
Switch on the machine by pressing the switch
(ref. 1, pos. 9a) and leave it to run for a few min-
utes to eliminate any dirt and air bubbles from
the water circuit, then switch it off, connect the
high pressure line to the spray gun (ref. 4) and
fit the spray rod (ref. 5). Make sure that the de-
tergent regulator is in the closed position.
When the machine is running again, check that
the jet is even; otherwise, clean the nozzle to
remove any dirt. Wait a few seconds for the op-
erating pressure to be reached, then operate
the gun for two or three short bursts.
To wash with hot water, press the switch (ref. 1,
pos. 9b) and turn the thermostat (ref. 1, pos. 10)
to the desired temperature setting.
> LANCE ASSEMBLY
To fit the lance to the gun, it is sufficient to in-
sert the threaded end of the lance (ref. 5, pos.
1) into the hole on the gun (ref. 5, pos. 2); then
screw the lance as shown by the arrow (A) until
the connection is tight.
>

DETERGENT SUCTION

Fill up the detergent tank with the suggested
products, suitable for the kind of washing to be
carried out (ref. 1, pos. 12b).
•
CAUTION: Make use only of liquid deter-
gent, do not absolutely use acid or too
much alkaline products. We suggest you to
make use of our products, which have been
studied for the use with washer machines.
•
CAUTION: For proper use of the tank, do
not introduce flammable or chemically
harsh substances.
The detergent can be delivered in two ways
depending on how your model is equipped: ei-
ther by low/high pressure nozzle or by a button
located on the electric panel
- LOW/HIGH PRESSURE NOZZLE
The adjusting head allow you to select water jet
at low and high pressure. The pressure selection
is carried out by rotating the adjusting head. To
increase the pressure, rotate the adjusting head
clockwise (ref. 6, Pos. A), to reduce the pressure
rotate it anti-clockwise (ref. 6, pos. B). The de-
tergent suction is automatic when the adjust-
ing head of the lance is rotate for low pressure
operation (anti-clockwise). When you start the
machine, the mixing of the detergent with the
water is automatic at the water passage.
- BUTTON LOCATED ON THE ELECTRICAL
PANEL (OPTIONAL)
Operate the button, press the gun: the deter-
gent is mixed with high pressure water.
> GUN SAFETY DEVICE
Whenever the machine has to be stopped, it is
important to engage the safety catch (S, ref. 10)
on the gun so that it cannot be operated acci-
dentally.
23