LAVOR Pro Reno Manual Del Usuario página 17

Safety - Before using for the first time - Usage
Electrical power supply
Warning: Before connecting the
•
appliance, ensure that the specifications
listed on the identification plate match
those of the mains electric supply and
that the socket 17 is protected by a
differential magneto-thermal circuit
breaker with a trip threshold less than
0.03A - 30ms.
• If the mains power lead or plug is
damaged, have it repaired or replaced
by a customer service centre.
• Do not use the appliance at
temperatures lower than 0° C.
• The appliance shall be connected to
the electrical network providing that
the impedence Zmax<0.23
Caution: Non-approved extension
leads may be dangerous and must
never be used.
• If an extension lead is used, both the
plug and the socket must be waterproof
and the cable cross section must be as
specified in the following table.
230-240V
1,5 mm max 20 m
2
2,5 mm max 30 m
2
Before using the first time
Warning:
• Before assembly, ensure that all
appliances and accessories listed in the
chapter "Equipment" are present.
• Each unit is test run after manufacture,
therefore you may find some residual
water in the water intake.
Assembling the appliance
1. Photo sequence D:
• Please take the handle 12 and fix it to
the machine back part, using 4 screws
• Please take the detergent tank and
fix the detergent hose on the rubber
holder.
• Please take the accessory holder ad fix it
to the handle as shown in pictures 4-5
• The hose support as per picture 6, is
included only if the machine is supplied
without the hose reel.
2. Photo sequence E:
Note: Turn the appliance around to face
the rear of the unit for the following
sequence of instructions.
• The hose reel 9 consists of 4 pieces.
• Please take handle 10 and insert it its
seat, first insert the small pin then the
bigger one (picture 2).
• Please insert the whole handle into the
hole on the hose reel (picture 3-4).
• Please take the central cylinder and
fix the hose reel 9 to the accessory
holder, using 2 screws (picture 5-6).
• Please place the high pressure hose
end 3 onto the hook of the hose reel
and roll completely up. We suggest to
lubricate the cylinder before fixing the
hose reel, this will help to operate it.
• Connect the short high-pressure hose
connector 3 to the spray gun quick
release connector. Lift the ring on the
spray gun mount 2 , insert the end of
the hose 3 and release the ring. Check
that it has engaged correctly.
Usage
Caution: For safety reasons, always use
both hands to assemble the nozzle 1 and
spray gun 2 before starting a job.
Connection to the water mains
(Photo A-B-C)
17 Plug/wall socket
18 Water tap
19 Water supply hose
20 Water inlet (INLET)
21 Water filter
22 Mounting
23 Snap-on hose connector (optional)
24 Spray gun safety catch
25 Spray gun trigger
EN
17