Publicidad
Step 15
Carefully stand your unit upright.
å
Insert the SHELF RESTS (10) into the hole locations of your choice in the RIGHT END (B) and UPRIGHT (C). Set the
å
ADJUSTABLE SHELF (G) onto the SHELF RESTS.
Before fastening the DOORS to your unit, be sure the mounting screw is against the outer end of the slot as shown in
å
the right diagram. If it isn't, loosen the adjusting screw and mounting screw to slide it against the end of the slot. Then
tighten the mounting screw.
Fasten the LEFT DOOR (L) to the LEFT END (A). Use the SCREWS in the HINGES.
å
Fasten the RIGHT DOOR (M) to the RIGHT END (B). Use the SCREWS in the HINGES.
å
Fasten two PULLS (16) to the DOORS (L and M). Use four 5/8" MACHINE SCREWS (21).
å
A
Page 20
C
B
G
L
16
www.sauder.com/service
Slot
Mounting
screw
M
(4 used)
10
16
5/8" MACHINE HEAD SCREW
(4 used in this step)
17
Adjusting
screw
Hinge
10
21
429579
Publicidad
