Midland ENERJUMP Manual Del Usuario página 12

CHARGING ENERJUMP
1. Plug the wall adaptor into the universal socket.
1. Connect the 14V-1A input port of of ENERJUMP to the other end of
the wall charger.
or
2. Plug the car adaptor into the socket of the cigarette lighter.
3. Connect the 14V-1A input port of ENERJUMP to the other end of the
car adaptor.
STARTING A VEHICLE
1. Make sure that ENERJUMP is properly charged (the number of the
indicator lights must be not less than 3).
2. Turn off all the accessories on the vehicle.
3. Connect the red battery clamp of the jumper cable to the vehi-
cle's positive (+) battery terminal and connect the black battery
clamp to the vehicle's negative (-) battery terminal. Warning: pay
attention to the polarity! A reverse polarity connection (positive to
negative) may cause damage to ENERJUMP and/or create a spar-
king/explosion hazard.
4. Plug the cord of the jumper cable into the jump start socket.
5. Turn the ignition key to start the vehicle for 3 seconds
6. If the engine starts, remove the jumper cable from ENERJUMP and
disconnect the red and black clamps from the vehicle's battery
10 - ENERJUMP