Nilox 13NXAKRCEV005 Guía Introductoria página 3

Viewing angle switching buttons in the remote control can only be used in the 1080p mode.
When EVO REMOTE CONTROL accidentally crashes in use, can not be normal shutdown, you can press "
" key to forced shutdown.
Startup
Long hold the " " button for about 5s to start up the Wi-Fi based remote control.
After startup, the red power indicator will stay on and the screen will display the battery icon "
indicates that the battery level is low and charging is needed; please connect the USB power supply to the USB port of the remote
control for charging. Startup
Pairing
Please carry out pairing before enabling the functions of the remote control. Steps for pairing between the Wi-Fi based remote
control and the camera are stated as follows:
1. Turn on the camera and enable the Wi-Fi function;
2. First, press and hold the "
up the remote control.
3. Long press the " " button and the "
HOST PBC" appears.
4. Press the "Stop" button of the camera once, and the screen of the Wi-Fi remote control will display the icon below:
5. Press the " " button of the Wi-Fi remote control for connecting, and the screen of the Wi-Fi remote control
will display the icon below:
6. When the remote control enters the recording standby state and the following interface, code pairing is completed successfully:
" Button of the Wi-Fi remote control; then, long press the "
" button, and do not release these two buttons until the following icon of "WAIT
" and "
"; if the battery icon "
" record for about 5s to start
", it