Descargar Imprimir esta página

Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Generac 1539 0 El Manual Del Propietario

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning and Applying Chemical
CAUTION!
You must attach all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump.
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
• Review the use of the nozzles.
• Prepare the detergent solution as required by the
manufacturer.
• Place the chemical injection siphon/filter into the
detergent container.
CAUTION!
Keep the chemical injection tube from
coming in contact with the hot muffler.
• Make sure the black nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (White, Green, Yellow, or Red).
• Make sure the garden hose is connected to the water
inlet. Check that the high pressure hose is connected to
the spray gun and the pump and start the engine.
• Apply the detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes. Do Not allow the
detergent to dry on (prevents streaking).
• Allow the detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to prevent
surface from drying.

Pressure Washer Rinsing

WARNING!
Be extremely careful if you must
use the pressure washer from a ladder, scaffolding
or any other relatively unstable location. Hose
water pressure builds as you climb. When you press
the trigger, the recoil from the initial spray can be
very strong. The high pressure spray could cause
you to fall if you are too close to the cleaning
surface.
Generac Portable Products 3000 PSI Pressure Washer
After you have applied detergent, scour the surface
and rinse it clean as follows:
• Apply safety latch to spray gun.
• Remove the black chemical nozzle from the nozzle
• Select and install the desired high pressure nozzle
• Keep the spray gun a safe distance from the area you
• Increase or decrease spray pressure by turning the
• Apply a high pressure spray to a small area and then
• Start at the top of the area to be rinsed, working down
Automatic Cool Down System
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a temperature
between 125°–155°F. At this temperature, the system
engages and cools the pump by discharging the warm
water onto the ground. This system prevents internal
damage to the pump.
10
extension.
following the instructions "How to Use the Nozzles" on
page 9.
plan to spray.
pressure control knob counterclockwise or clockwise
respectively (Figure 13). Use lower pressure to wash
items such a as a car or boat. Use higher pressure to
strip paint and degrease driveways.
Figure 13 — Pressure Control Knob
check the surface for damage. If no damage is found, you
can assume it is okay to continue cleaning.
with same overlapping strokes as you used for cleaning.
(Thermal Relief)
Pressure
Control
Knob

Publicidad

loading