Roth Music Cocoon MC4 Manual De Instrucciones página 7

Getting Started
2 Speakers
3 Power
Note:
To protect power
4 If your iPod has video out, you can use S-video wire (not included) to
and speakers, the
volume will go
to the minimum
level position
5 Turn on the switch on the adapter
once you turn off
6 Press and hold 3 seconds on the volume switch of the amplifier or on the
the amplifier.
All manuals and user guides at all-guides.com
Connect the amplifier to the speakers with enclosed audio source wires
and make sure the L and R connection are correct. Select your speakers
with impedance greater than 8 ohm, otherwise you may damage the
amplifier system
WARNING:
Please note that wrong voltage
selection will damage your
amplifier system.
Insert the power cord into the rear panel of the amplifier. Select the
voltage on the adapter to your local voltage 110V or 230V. Connect the
power cord to the adapter and plug the other end into an AC wall jack
connect the amplifier to your TV or monitor.Then, you can enjoy watching
video files on TV or monitor
power button on the remote control to turn on the power.The red power
protection indicator lights up.Then it will flash about 15 seconds. In the
mean time, the tubes light up gradually. Once the indicator stops flashing,
the green LED will light up both on the volume and source selector.Then,
the tube system is ready to operate
ENGLISH
7