Pro-Lift T-5350 Manual De Funcionamiento De Piezas & De Instrucciones página 3

ASSEMBLY
1. Attach Hydraulic Unit to receiver platform and secure with provided bolts.
2. Install Lift Pedal into Sleeve.
3. Install rear handle into frame and secure using the provided pin.
4. Install Wheel Brackets using hardware provided.
5. After assembly, ensure lift rolls freely, lifts, locks and lowers easily, and that Bottle Jack operates smoothly before
putting into service. Familiarize yourself with operation of Height Locking Lever and Lift Pedal.
Hydraulic Unit
Oil Filler Plug
Release Valve
OPERATION
1. Position mower tires securely on Wheel Baskets, centering the load on lift. Mower transmission should be in
"NEUTRAL" and parking brake released during lifting and lowering.
2. To familiarize yourself with basic operation, rotate the release valve knob:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the ram plunger.
b. Counter-clockwise, but no more than 1 turn from the closed position. This is the 'OPEN' release valve position
used to lower the ram plunger.
3. Locate and pump the Lift Pedal until the Wheel Baskets begin to rise, monitoring mower and lift closely.
4. Continue pumping until load has reached desired height. Final height must correspond with the locking teeth on
the Height Locking Lever.
5. Turn the Release Valve counterclockwise until the Lift engages the Height Locking mechanism fully before working
on or around the loaded lift. Apply parking brake when mower is at desired height.
!
WARNING: Be sure all tools and personnel are clear before lowering load.
6. To lower lift, put the mower in neutral and raise Lift Platform slightly to disengage Height Locking Levers, then pull
Height Unlocking Lever back and carefully turn Release Valve counterclockwise, lowering the load slowly.
Lift Pedal
Height Unlocking
Handle
Casters
Figure 1 - Utility Lift Nomenclature
Hyd Unit
Hardware
3
Ram Connecting Pin
Wheel Brackets
Height Locking
Lever