Maintenance; Cleaning After Use - Sublue WhiteShark Tini V10 Manual Del Usuario

For the sake of safety, the battery or control handle should be kept at low battery power
11
during transportation. Discharge it before transportation and lower the battery power
capacity to 30%.
Don't use a damaged battery or control handle.
12
If the electrolyte enters your eyes after the battery leaks, don't wipe it. Apply water to rinse it,
13
and see a doctor immediately. If left untreated, your eyes will be hurt.
If stored for a long time, check the battery power at least every 6 months and charge the
14
battery power to 60%.

Maintenance

1

Cleaning after Use

After each use, WhiteShark Tini should be completely immersed in clear water for 30
1
minutes to avoid sea water or foreign objects. And pay attention to the following:
* Install the battery and start the power system before cleaning.
* Please use clean water.
* Immerse in water for more than 20 minutes .
* Don't add chemical cleaning products such as laundry detergents or cleaning
agent in clean water.
* When WhiteShark Tini is immersed in water, some bubbles are expelled from the
holes of the equipment body, which is not a malfunction.
Start the control handle and press the start button to make WhiteShark Tini run in half
2
air and half water for 10 seconds, and repeat this operation 5-10 times.
* To prevent the water from being splashed on your body during operation, please
push the propeller outlet to the bottom of the container.
* WhiteShark Tini has a large thrust force in the water. Don't dismantle the handle
bracket. Please apply the low speed and slightly raise the equipment out of water
surface for cleaning, which is easier to control.
20