Descargar Imprimir esta página

Yardistry YM11560 Manual De Instalación página 11

Publicidad

20"
Step 7- Layout Posts and
20"
Connectors
1. L ayout Arbour bases in configuration shown in figure 1. *Posts must be securely installed
to support structure.Consult local building codes and ground conditions for required
footing design. It is recommended the structure be secured to existing stone, concrete or
deck with the Yardistry Post Base (YM21016) or equivalent hardware.
2. I nstall Post Top Connectors with S6- 1 1/2" Pan Head Screws provided. (Fig. 2) Ensure the
direction of the Post Top Connector is the same direction as indicated by the arrows in figure 1.
78½"
20"
16x
1 1/2" Pan head Screws
S6
4x - Post Top Connector
This identifies information that requires special
78½"
attention. Improper assembly could lead to an
unsafe or dangerous condition.
Installer le Poteau 4 x 4 po et le Connector de Poteau 4 x 4 po.
L'espace entre Poteau 4 x 4 po et la direction de Poteau
Use
Use
connecteur et critical.
Help
Help
Measure
Check that assembly is square
Distance
before tightening bolts.
177 "
Use a measuring tape to assure
proper location.
CAUTION – Protrusion Hazard
Once the assembly is tightened, watch for exposed
threads. If a thread protrudes from the T-Nut, remove
the bolt and add washers to eliminate this condition.
Extra washers have been provided for this purpose.
132½"
Proper Hardware Assembly
Lag screws require drilling pilot
holes to avoid splitting wood. Only
a flat washer is required. For ease of
installation liquid soap can be used
on all lag-type screws.
Install on a flat
20"
For bolts, tap T-Nut into hole with
and level surface!
hammer. Insert the hex bolt through
lock washer first then flat washer then
78½"
hole. Because the assemblies need to
be squared do not completely tighten
until instructed. Pay close attention to
diameter of the bolts. 5/16" is slightly
larger than 1/4".
Note: Wafer head bolts with blue lock
tight or a bolt with a Ny-Lok nut do
NOT require a lock washer.
Fig. 2 - Attach Post Top Connectors
with S6- 1 1/2" Pan Head Screws.
Where this is shown, 2 or 3
people are required to safely
complete the step. To avoid
injury or damage to the
assembly make sure to get help!
Square
Assembly
177 "
Lag Screw
Fig. 1
Hex Bolt
5
11
Check that set or assembly is properl
before proceeding.
20"
Pre-drill 1/8" & 3/16" Bit
This indicates time to tighten bolts, b
not too tight! Do not crush the wood.
This may create splinters and cause
structural damage.
No
Lag Assembly
20"
20"
Flat Washer
Bolt Assembly
Lock
Washer
Flat
Washer
6
20"
Pre-drill a pilo
before fasteni
or lag to prev
splitting of wo
78½"
If Bolt protrude
beyond T-Nut
Use an extra
Flat Washer
Be
use
gu

Publicidad

loading