Storing Stations Into Memory - Eton E5 Guía De Funcionadmiento

SETTING THE CLOCK AND WEEKDAY
The E5's clock is in 24-hour format. Turn off the E5.
1. With the E5 off, press the PAGE/TIME button for about 2 seconds
or until the hour digits start flashing.
2. Within 3 seconds, use the tuning knob to set the correct hour;
then press F1-7 to highlight the days you wish the alarm to
activate.
3. Immediately press PAGE/TIME again, noting that the minute digits
start flashing.
4. Within 3 seconds, use the tuning knob to set the correct minutes.
5. Immediately press PAGE/TIME again. The clock is set.
ACTIVATING AND DEACTIVATING THE ALARMS
For an alarm to turn on the radio, it must be activated. To activate
the alarm to be used, turn off the E5 and press the appropriate alarm
button, F1-4. This causes the timer activation symbol to appear in
the upper left corner of the display, activating the selected alarm. To
deactivate the alarm, press the appropriate F1-7 button, causing the
alarm activation symbol to disappear.

STORING STATIONS INTO MEMORY

The E5 has 700 memories (also called presets), arranged in 100
pages, with each page holding 7 memories. Buttons F1-7 represent
memory locations.
Note that when storing into an already occupied memory position, its
contents will be replaced with your new entry.
1. Turn on the E5.
2. Tune to the desired station.
3. Press the PAGE/TIME button to place the E5 into MEMO mode.
10
E5 OWNER'S MANUAL