GET RX1 PRO Guia De Instalacion página 3

REMEMBER TO WORK UNDER SAFETY CONDITIONS
AND TO KEEP THE ENGINE TURNED OFF.
1.
Remove the rear side panels,
the muffler, the voltage regulator,
and the ECU protective cover.
2.
Find the OEM ECU: check
on your motorbike's workshop
manual where to find it. Press
the retainer clip of the OEM ECU
connector before pulling it: make
sure to remove the connector
without damaging it.
3.
Insert the GET RX1 Pro ECU
into the rubber support and
connect it to the OEM connector.
Make sure the connectors are
properly plugged in, and the
retainer clip is fully engaged.
4.
Pass the 3 connector wires of
GET RX1 Pro ECU through the hole
of the OEM ECU protective cover.
Put the 3 RX1 Pro connectors
behind the voltage regulator so
that it can protect the connectors.
ATTENTION: DO NOT PINCH THE WIRES!
EN 4
5.
Install GET Map Switch by
following the instructions in "Map
Switch Installation" Section in
GET RX1 Pro manual.
ATTENTION:
OEM handlebar commands for traction control and
map switch will not work after installing GET RX1
Pro ECU. Please only use GET Map Switch (included
in the kit) and GET LC-GPA module (sold separately).
The OEM mode button (blue one) can be used to
manage GET LC-GPA when installed.
6.
If included in the kit, install
GET WiFi-COM by following the
procedures in the dedicated manual.
7.
Re-install all the components
removed in the first step.
F. SYMBOLS AND CERTIFICATIONS
We declare that this product supplied is compliant with
RoHS Directive 2011/65/EU amended by the Directive
2015/863/EU (RoHS3) relative on the Restriction of
the Use of Certain Hazardous Substances.
5 EN