Filling The Magazine; Eu Declaration Of Conformity - BEA R20/160-1603E Manual Del Usuario

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap. 3):
•
The driving nose must point away from any person. It must be
impossible to unintendly actuate trigger and/or release protection.
Pull pusher 1 backwards and engage. Insert nail strip 2 into the
•
magazine from above and push forward. Disengage the pusher
and push it forward.
5 Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Loosen screw
•
1 on the release bracket and push release shoe 2 downwards for
less recessed clamps or upwards for more recessed clamps. Then
tighten screw 1 firmly again and connect the tool with compressed
air.
6

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied: EN
ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools); EN
12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
1603 E
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7