Fein GRIT GIMS75 Manual Del Usuario página 9

OBJ_BUCH-0000000341-001.book Page 9 Monday, October 8, 2018 11:37 AM
Daily maintenance
Blow out the ventilation slots (23) at the motor
housing and the marked locations with compressed
air (see Instruction label (25)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (25)).
Check the drive disc (12) and the contact disc (13) for
wear and damage each time when replacing a grinding
belt. Have damaged parts replaced.
After sufficient cooling down, remove any deposits in the
housing. These may only be disposed of with suitable
containers.
Lubricate the bearings of the tensioning device monthly
via the lubricating nipple (24).
Cleaning the exterior of the machine with compressed
air.
If required, you can change the following parts yourself:
Grinding belt, spark guard
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's warranty declaration.
The delivery scope of your machine may include only a
part of the accessories described or shown in this instruc-
tion manual.
Environmental protection, disposal.
Packaging, worn out machines and accessories should be
sorted for environment-friendly recycling.
Connection diagrams.
Type GIMS75/GIMS150
440 V/254 V, 400 V/220 V
GIMS75-6/GIMS150-6
440 V/254 V, 400 V/220 V
GIMS75-6/GIMS150-6
575 V/332 V
Page 20
Type GIMS75/GIMS150
230 V/220 V
GIMS75-6/GIMS150-6
230 V/220 V
Page 21
Type GIMS75 2H/GIMS150 2H
440 V/254 V, 400 V/220 V
Page 22
en
9