Troubleshooting; Disposal - Parkside PDSS 310 B5 Traducción Del Manual De Instrucciones Original

■ Use only the genuine replacement parts
recommended by the manufacturer, otherwise
you could put users at risk . In doubt, contact the
Service Centre .
■ Clean the tool with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .

Troubleshooting

Possible
Fault
cause
Motor parts
jamming due
to dirt .
Speed too
slow, air is
escaping from
the outlet .
Pressure sup-
ply too low .
Tool will not
Motor is
move; all com-
jammed due
pressed air es-
to material
caping through
build-up .
the outlet .
■ 12 │ GB │ IE

Disposal

Do not dispose of the appliance in the normal
domestic waste!
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance .
Remedy
Check filter of
the pressure sup-
ply for contami-
ponents for disposal if necessary . The packaging
nation, clean and
material is labelled with abbreviations (a) and
lubricate the de-
numbers (b) with the following meanings:
vice .
1–7: plastics, 20–22: paper and cardboard,
Check the pres-
80–98: composites .
sure supply filter
for contamina-
tion .
If necessary, re-
peat the steps
outlined above .
Check filter of
the pressure sup-
Dispose of lubricants and cleaning agents in an
ply for contami-
environmentally friendly manner . Observe the
nation, clean and
legal regulations .
lubricate the de-
vice .
■
■
The packaging consists of environmen-
tally friendly material . It can be dis-
posed of in local recycling containers .
Dispose of the packaging in an environ-
mentally friendly manner . Note
the labelling on the packaging and
separate the packaging material com-
Your local community or municipal
authorities can provide information on
how to dispose of the worn-out product .
The product is recyclable, subject to
extended producer responsibility and
is collected separately .
Dispose of lubricant residues at a disposal
point . Do not allow lubricants to enter drains or
watercourses . Do not allow them to get into the
subsoil/soil . Make sure you use a suitable mat/
surface . Dispose of lubricants in accordance
with official regulations .
Dispose of contaminated maintenance material
and consumables at a collection point provided
for this purpose .
PDSS 310 B5