Led Display / Charging Process - Ecom Instruments Ex-PMR 1000 Instrucciones De Uso

PS PMR 1000 for charging. The battery may only be charged outside the Ex-area!
The battery module can be charged together with the EX-PMR 1000 or separately

9.2 LED display / Charging process

An LED display is located on the front side of the charger to indicate the charge status.
ERROR
CHARGING
FULLY CHARGED
If the charger is connected to the power supply unit, The LED will not illuminate. When an
Ex-PMR 1000 with mounted or individual Ex-AM PMR 1000 is inserted, the LED illuminates in
red (CHARGING).
Charging is complete after about 4 hours and the LED illuminates green (FULLY CHARGED).
In case of failure, the LED flashes red (ERROR) and the Ex-PMR 1000, or the battery module,
must be removed from the charger immediately. The battery module and charger should be
sent off to ecom instruments GmbH for inspection.
Battery care
- The battery should be completely charged before use.
- Note that the maximum capacity of the battery is achieved only after about six charging
and discharging cycles.
- Since the performance of batteries declines over time, they should be completely
discharged occasionally to maintain their full capacity. When doing this, leave the unit
turned on until it turns itself off. Subsequently fully charge the battery pack
Ex-AM PMR 1000 outside of the Ex-area.
All manuals and user guides at all-guides.com
(see illustration). Please observe: Charging
temperature range: 0°C .....40°C.
33