Schlage FE595 Instrucciones De Instalación página 3

8
Place battery in holder and tuck wires.
9
Install cover.
Test Lock
Temporary Unlocking
1. Find User Code A on the
cover of these instructions.
2. Enter User Code A
(four digits) into the
keypad.
3. Rotate and then
release lever.
Locking
The lock will automatically relock itself, until a valid user code is
entered.
Route wires behind curved
piece and tuck, using tabs, so
they will not be pinched by the
cover.
Tabs
Curved Piece
Actual Size
10
If needed, switch levers.
Correct
Incorrect
c
Repeat steps a and b to remove the
lever from the other side of the door.
Switch the levers.
Did latch retract and then extend?
Yes. Lock is installed correctly.
No. Latch retracted but did not extend (latch
bound). Check step 4.
No. Nothing happened. Check steps 7 and 8.
To Set to Unlocked
1. Rotate the inside thumbturn
to the vertical position.*
* No User Code is required to open the door when the lock is set to unlocked.
If your lever looks like this,
then no change is necessary.
If your lever does not look
like this, switch the levers by
following the steps below.
OR
a b
Insert the pin wrench Pull the lever off.
into the hole in the
lever. Push in and hold.
d
Push each lever back
into place.
2. Rotate the thumbturn back to the
horizontal position to re-lock.