First Time Use; Inflation Operation - Seamax SUP16DBPRO Manual Del Usuario

Seamax Portable 12V SUP-16DB Electric Air Pump with Built-in Lithium Battery
for Inflatable SUP, Kite and Inflatable Boat www.seamaxmarine.com 1877-907-7766

First Time Use

▪
Use the provided charger to fully charge the built-in battery.
▪
Select the right valve adapter and an O-Ring with correct thickness to fit the inflatable product's air
valve.
▪
Use the original valve adapter if it provides better inflation result.
▪
Press and hold the Power ON/OFF button for 1 second to turn on the pump. Test run the pump before
the first-time use. The pump can be stopped any time by pressing its power button.
▪
Inflate one SUP / Paddle Boat at a time. Do NOT let the pump continuously running for more than 20
minutes as extended usage beyond its recommended running time may cause overheating and damage
to the internal inflator.
▪
Using smaller valve fittings limits the airflow speed, and thus the pump is easier to get overheated. For
this type of application, the max 20 minutes continuous working time must be adjusted accordingly.
▪
Instable low-quality power source decreases the pump's running performance, and the time to complete
inflating a product will be increased. It may cause overheating issue and damage the pump's inflator. Do
NOT operate the pump with any low-capacity, low-voltage, and low-quality battery.
▪
If the air hose section near the pump port is heating up to over 60ºC (92ºF), stop using the pump
immediately and let it cool down first.
▪
If the environment temperature is too high, the pump's maximum continuous working time will be
reduced accordingly.

Inflation Operation

▪
Turn on the pump when the battery is fully charged, OR
▪
Plug the pump's power adapter into a vehicle's 12V DC socket, or clip to a battery with a convertor.
▪
Connect the end of flexible conduit adaptor of the air hose with the air pump inflation port, and twist
clockwise to tighten it.
▪
Insert the other end of the air hose into the supported product's air valve and twist clockwise to connect
▪
Press the air pressure unit toggle button [PSI/BAR] to select or switch the preferred unit (PSI or BAR).
▪
Press the Increase Air Pressure button [+] or Decrease Air Pressure button [-] to set the desired target
pressure value matching the inflatable product's air pressure requirement from 0.5 PSI to 16 PSI (1PSI =
0.0689BAR). The pressure setting increment is 0.5 PSI.
▪
Press the On/Off power switch button to start the pump.
▪
During the inflating process, the Increase Air Pressure button [+] or Decrease Air Pressure Button [-] can
be pressed to adjust the target air pressure value. Pressing the On/Off power button can stop pumping
manually.
▪
During the inflating process, the LCD screen displays the inflatable product's on-going real time air
pressure. The preset target air pressure number appears in every 3 seconds in a flashing mode for the
user's information.
POWER PROTECTION – HOLD THE POWER BUTTON FOR 1 SECOND TO START THE POWER
Page 4