First Time Use; Inflation Operation - Seamax SUP20S PRO Manual Del Usuario

Seamax Portable12V Electric Air Pump for Inflatable SUP and Paddle Board
▪
You can use your original valve adaptor other than the coming valve adaptors, if it is better result.
▪
Test Run is necessary before your first time using. You can stop the pump any time by pressing its power button. Don't leave
the pump running unattended even considering its auto stop feature!
▪
Do not use it for more than 20 minutes continuously. That means one SUP or Paddle Boat at a time. Long periods of use
can cause overheating and damage the inflator.
▪
Smaller valve fittings can limit the airflow speed, the pump could be easier to get overheat. Your attention is very important
in those cases, and the pump 20 minutes continued working time must be reduced.
▪
Low quality power source will slow down the pump running, it can cause the pump over heat quickly and damage the pump
easier. We do not suggest operating the pump with low capacity battery or battery low.
▪
If hose (pump side) temperature is over 60ºC (92ºF), please stop using the pump to let it cool down first.
▪
If the environment temperature is too high, the max pump continued working time may be reduced.
▪
Plug the pump power adapter into the car's 12V DC socket, or to a battery with a convertor.
▪
Press the air pressure unit toggle button [PSI/BAR] to select your preferred unit such PSI or BAR.
▪
Press the Increase Air Pressure button [+] or Decrease Air Pressure button [-] to set the desired target pressure value
matching with your inflatable product's air pressure requirement from 0.5 PSI to 20 PSI (1PSI=0.0689BAR).
▪
The pressure setting increasement is 0.5 PSI. Press the On/Off power switch button to start the pump.
▪
During the inflating process, you can press the Increase Air Pressure button [+] or Decrease Air Pressure Button [-] to
adjust the target air pressure value. Press the Air Pressure Unit toggle button [PSI/BAR] to switch the air pressure unit.
Pressing the On/Off power button can stop pumping manually.
▪
During the inflating process, the LCD screen displays the inflatable product's on-going real time air pressure. The preset
target air pressure number will appear in every 3 seconds in flashing mode for the user's information.

FIRST TIME USE

INFLATION OPERATION

Page 7
www.seamaxmarine.com 1-877-907-7766
Connect the Flexible conduit adaptor
of the hose with the air pump inflation
port. Twist clockwise to tighten it, as
Figure 1.
Connect the other end of the air hose
with air valve adapter to a supported
inflatable product's air value. Twist
clockwise to tighten it, and then
connect this air hose to the chamber,
as Figure 2.