Uline H-7545 Manual De Instrucciones página 2

CART ASSEMBLY
1. Attach front door to left and right side panels by
inserting Phillips head bolts into threaded inserts in
panels. The top flange of front door must go over
side panel and fit into slit at top of side panel.
(See Figure 1)
NOTE: Each side panel has two shelf louver
channels. Make sure that the wider shelf louver
channels are closer to the back of the unit.
2. Attach back panel to left and right side panels by
inserting Phillips head bolts into threaded inserts in
panels. The top flange of back panel must go over
side panel and fit into slit at top of side panel.
(See Figure 1)
Figure 1
3. Attach casters to holes in bottom rails underneath
cabinet. Secure with locknuts. (See Figure 2)
NOTE: Make sure swivel casters are on same
side of unit and swivel casters with brake
casters are on the other side.
Figure 2
PAGE 2 OF 12
Side
Panel
Back
Panel
ASSEMBLY
4. Insert bottom into cabinet with circular opening
towards back of unit. Push down until secure.
(See Figure 3)
5. Install shelf at desired level in cabinet by inserting
tabs into louvers on side panels. (See Figure 3)
NOTE: Shelf should have lips facing up and
install like a tray.
Figure 3
6. Attach upper left and right panels to upper
compartment panel using self-tapping screws. The
louver on left and right panels should be closest to
the upper compartment panel, with the open end
of louver facing towards open end of assembly.
(See Figure 4)
Figure 4
Louver
Compartment Panel
Bottom
Self-tapping
Screw
Upper Left
Panel
Upper
Upper Right
Panel
0721 IH-7545