Bench Mounting; Changing Or Installing A New Saw Blade; Removing The Blade - DeWalt DW713 Manual De Instrucciones

Recommended accessories for use with your tool are available for purchase from your local
dealer or authorized service center. If you need assistance in locating any accessory for
your tool, please contact D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore,
E
MD 21286, call 1-800-4-D WALT (1-800-433-9258) or visit our website www.dewalt.com.
E

Bench Mounting

Holes are provided in all four feet to facilitate bench mounting, as shown in Figure 2. (Two
different sized holes are provided to accommodate different sizes of screws. Use either
hole, it is not necessary to use both.) Always mount your saw firmly to prevent movement.
To enhance the tool's portability, it can be mounted to a piece of 1/2" (12.7 mm) or thicker
plywood which can then be clamped to your work support or moved to other job sites and
reclamped.
NOTE: If you elect to mount your saw to a piece of plywood, make sure that the mounting
screws don't protrude from the bottom of the wood. The plywood must sit flush on the
work support. When clamping the saw to any work surface, clamp only on the clamping
bosses where the mounting screw holes are located. Clamping at any other point will surely
interfere with the proper operation of the saw.
CAUTION: To prevent binding and inaccuracy, be sure the mounting surface is not
warped or otherwise uneven. If the saw rocks on the surface place a thin piece of material
under one saw foot until the saw sits firmly on the mounting surface.
FIG. 2
LEFT SIDE FENCE
CLAMPING KNOB
BENCH
MOUNTING
HOLES
WRENCH
HOLES FOR
EXTENSION KIT
Changing or Installing a New Saw Blade (Fig. 5, 6)
and disconnect it from the power source before attempting to move it, change
accessories or make any adjustments accept as written in laser adjustment
instructions.

Removing the Blade

OPERATING
HANDLE
GUARD
RIGHT SIDE
FENCE
TABLE
MITER LOCK
LEVER
MITER SCALE
BASE
5
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of serious personal injury, turn off the tool
CAUTION:
• Never depress the spindle lock button while the blade is under power or coasting.
• Do not cut ferrous metal (containing iron or steel) or masonry or fiber cement product
with this miter saw.
1. Unplug the saw.
2. Raise the arm to the upper position and raise the lower guard as far as possible.
3. Loosen, but do not remove guard bracket screw until the bracket can be raised far
enough to access the blade screw. Lower guard will remain raised due to the position
of the guard bracket screw.
4. Depress the spindle lock button (Fig. 3) while carefully rotating the saw blade by hand
until the lock engages.
MOTOR
FIG. 3
END CAP
SPINDLE LOCK
BUTTON
MOTOR
HOUSING
LEFT SIDE
FENCE
MITER
MITER
DETENT
SCALE
MITER
DETENT
OVER RIDE
TRIGGER
SWITCH
CARRYING
HANDLE
DUST
SPOUT
BEVEL CLAMP
KNOB
BEVEL
HAND
SCALE
INDENTATION