Black and Decker BDJS450I Manual De Instrucciones página 5

Do not probe the charger.
The battery must be placed in a well ventilated area when
charging.
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
o
130 C
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
Read all of this instruction manual carefully.
This appliance is intended for indoor use only
Electrical safety
This appliance is double insulated; therefore no
earth wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features:
1. Inflator on/off switch
2. Air hose with universal valve adaptor
3. Pressure gauge
4. Heavy-duty copper clamps
5. LED area light on/off switch
6. Reverse polarity indicator
7. Jumper cables
8. Mains charging adaptor
9. ON/OFF switch
10. LED area light
11. Battery status pushbutton
12. Carry handle
13. Battery status LEDs
14. 12 Vdc charging socket
15. Accessory storage
16. Clamp holders
All manuals and user guides at all-guides.com
USE
Charging the unit (fig. A)
This unit is shipped in a partially charged state.
Lead-acid batteries require routine maintenance to ensure a
full charge and a long battery life. All batteries lose energy
from self-discharge over time and more rapidly at higher
temperatures. When the unit is not in use, Black & Decker
recommend that the battery is charged at least every 60
days.
Note: Charging the battery after each use will prolong the
battery life; frequent heavy discharges between charges
and/or overcharging will reduce battery life.
The battery can be charged using the mains charging
adaptor (8).
Charging the unit with the mains charger (fig. A)
Make sure that the ON/OFF switch (9) and the LED area light
(10) are turned off while the unit is being charged.
As charging progresses, the red LEDs will light one by one.
Note: The mains charging should not be connected for more
than 60 hours.
Using the unit as a jump-starter (fig. A)
Warning! Make sure that the vehicle is in neutral with the
parking brake applied.
Note: If your connections are incorrectly made, the unit will
beep continuously and the red reverse polarity indicator (6)
will illuminate, even if the ON/OFF switch (9) is in the OFF
position. Rectify the connections immediately.
Warning! Make sure that the cables are not in the path of
moving belts or the fan.
Charge the unit before first use using the mains
charging adaptor (8) for 48 hours.
Check the battery charge level by pressing the battery
status pushbutton (11). The LED charge status display
(13) will indicate the level of battery charge. When only
one red LED lights, charge the unit.
Charge the unit until the green FULL LED lights.
Continue to charge for one to two more hours.
When charging is complete, disconnect the mains
charging adaptor (8) and store it in a safe place.
ENGLISH
5