Placing Tool In Service - Ingersoll Rand 280 Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. FRL30–C6–A29
For USA– No. C31–06–G00
After each forty–eight hours of operation, or as
experience indicates, inject about 3 cc of Ingersoll–Rand
No. 100 Grease into the Grease Fitting (2).
Model Type of
Handle
280 grip
280–6 grip
280–S6 grip
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested to ISO8662–1 loaded with frictionbrake to 9 RPM
•
ISO3744
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
620 kPa) Maximum air pres-
sure.

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 100
SPECIFICATIONS
Drive Impacts
per min.
in.
1" sq. dr., 750
inside trigger
1" X 6" 750
extended
sq. dr, inside
trigger
No. 5 X 6" 750
splined dr.,
inside trigger
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
WARNING
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended
Torque Range
ft–lbs (Nm) Pressure
150–1000 109.1
(200–1360)
150–1000 109.1
(200–1360)
150–1000 109.1
(200–1360)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
HSound Level
dB (A) Level
•Power
m/s
122.1 14.1
122.1 10.8
122.1 10.8
2