Mellerware Mixy! Manual De Instrucciones página 7

Ensure the blade fixing ring is fixed
–
properly to the jar (by turning
counter clockwise) before putting
on the motor body. (Fig.1).
Place the jar onto to the motor unit
–
until it fits properly into place (Fig.2).
Put the ingredients, after having
–
first chopped them into small
piece, into the jar with liquid (do not
exceed the maximum marker).
Put the lid on the jar; make sure it is
–
properly fixed in place.
Put the cup in the lid.
–
Connect the appliance to
–
the mains.
The pilot light (I) comes on.
–
Turn the appliance on, by using the
–
selection knob.
If you wish to add more ingredients
–
pull out the cup.
Add the ingredients and replace
–
the cup.
To stop the appliance set the
–
speed back to "0".
To avoid a fierce, start up of the
–
fan, it is advisable to start off from
the lowest speed position and,
once the fan has been switched on,
progressively increase the speed to
the desired position.
ELECTRONIC SPEED CONTROL
The speed of the appliance can
–
be regulated by using the speed
regulator control (I). This function
is very useful, as it makes it
possible to adapt the speed of the
appliance to the type of work that
needs to be done.
ONCE YOU HAVE FINISHED USING
THE APPLIANCE
Stop the appliance, selecting
–
position 0 on the selector control.
Unplug the appliance from
–
the mains.
Lift the jar from the motor body.
–
Clean the appliance.
–
"PULSE / ICE CRUSH" FUNCTION
The appliance works in highest speed
–
to achieve optimal performance.
This function gives optimal result
–
for ice-crushing, up to desired
snowy level.
Turn the speed selector knob to the
–
left to operate the Pulse function (J).
We recommend working by turning
–
the knob in cycles of 3 seconds and
repeating the operation until you
obtain the desired result.
SAFETY THERMAL PROTECTOR
The appliance has a safety device,
–
which protects the appliance
from overheating.
If the appliance turns itself off and
–
does not switch itself on again,
disconnect it from the mains
supply, and wait for approximately
15 minutes before reconnecting.
If the machine does not start again
–
seek authorised technical assistance.
Cleaning
Disconnect the appliance from the
–
mains and allow it to cool before
undertaking any cleaning task.
EN