Publicidad
Idiomas disponibles
Idiomas disponibles
10
English
GB
Functional
description:
The cornering light allows the
driver to recognise persons or
objects on the roadway more
Anbaumaße:
Installation
dimensions:
Upright and pendant mounting
are possible. The headlamps
must not vibrate or project above
the bonnet and must be attached
symmetrically.
Mounting steps:
See fig. on page 3
1. Fix mounting position and mark
attachment points according to
the above-mentioned installation
dimensions.
Electrical connection:
Anbaumaße:
See fig. on page 4/5
Place the unloaded vehicle on an
even surface.
quickly. When the driver activates
the direction indicator to turn
off at a junction or the vehicle is
steered into a bend, the cornering
light is switched on automatically
in addition to the low beam
depending on the speed of the
min.
600
mm
2. Pre-drill with 3 mm and then
drill the hole with 8.5 mm bits.
Seal the drilled metal parts using
corrosion protection.
3. Pre-mount the bracket and
tighten the screws by hand.
Loosen the ground cable to the
battery.
Find a splashwater-proof instal-
lation location for the control unit.
Bottom plug-type connections.
Align control unit vertically and
horizontally using a spirit level.
vehicle. For this purpose, the
control unit evaluates the indicator
light and bend driving up to a
speed of 40 km/h. To increase
the comfort of this light function,
the light is not switched off again
abruptly but rather dimmed
≤ 800 mm
min. 250 mm
max.
400
mm
4. Screw the headlamps in the
correct position to the pre-
mounted bracket and tighten the
screws by hand.
Fig. A
Note - Make sure left and right
Maximum permissible deviations
± 10°. Deviations can lead to
faulty functions.
(Fig. B).
Attach using Parker screws or
metric screws.
gradually according to time
parameters. In addition, the
cornering light can also be
circuited in such a way that
it takes over the function of
a complete fog lamp system.
Tools required
Metre rule
Universal pliers
Open-end or ring spanner SW 13
Open-end or ring spanner SW 8
Drill with drill bits dia.
3 mm, 8.5 mm, 12 mm
Cross-slot screwdriver
Spirit level
lamps are mounted the right
way round!
Reflectors radiate
asymmetrically outwards.
The Hella logo must always
be legible.
Seal the drilled metal parts using
corrosion protection.
Wire up the connection cables
provided carefully according to
the circuit diagram and secure
them with cable ties.
Publicidad
