Maintenance; Replacing The Lamp - Sony VPL-X2000U Manual De Instrucciones

Maintenance

Replacing the Lamp

When the lamp has burnt out, the LAMP FAIL
indicators at the rear of the projector light. In this case,
replace the lamp with a new LMP-Q2000 Projector
Lamp (not supplied).
Note
Immediately after turning off the power, the lamp is
extremely hot. Wait at least one hour before changing
the lamp to give it enough time to cool down.
To remove the lamp
1
Press the STANDBY key to set the projector to
standby mode, and unplug the power cord.
2
Remove the two screws with a coin or similar
object, or a screwdriver, to open the lamp cover.
3
Loosen the two screws that fasten the lamp.
4
Fold out the levers up and down.
48
(GB)
5
Pull out the lamp by holding the handles.
To install a new lamp
1
Mount the lamp with the grooves on the top and
bottom aligned with the guides on the projector.
2
Push the lamp completely until it clicks.
Fold down the levers to fix the lamp to the
projector.
3
Tighten the two screws to secure the lamp.