Charge / Discharge Processes With A Bid Chip; Terminating A Charge / Discharge Process - ROBBE POWER PEAK FUN Manual De Uso

'SELECT' button
'SELECT' button
'SELECT' button
'SELECT' button
'SELECT' button
8. CHARGE / DISCHARGE PROCEDURES WITH BID CHIPS
'MODE' button
cess; in our example 'C' for charging.
Even during a charge / discharge process it is possible to optimise the parameters using
the 'SET' buttons. If you change a setting, the process continues to run with the new
values. You can check the values by calling up the individual working displays in turn
using the 'SELECT' button.
9.

TERMINATING A CHARGE / DISCHARGE PROCESS

At the end of a charge / discharge process a brief audible signal sounds, and the screen
displays the message 'READY' briefly. This applies the termination is automatic or manual
(by operating the 'MODE' button, because (say) the battery is fully charged)
All manuals and user guides at all-guides.com
Operating instructions
POWER PEAK FUN
Once you have programmed all the settings on the
chip, the battery must be connected. The charge /
discharge process is initiated by selecting the
desired mode of operation using the 'MODE' but-
ton.
The selected process - e.g. 'CHARGING' - is dis-
played briefly on the screen, then this display
'flows' to the right and out of the screen, to be
replaced by the last activated working display. The
flashing status symbol indicates the current pro-
36
Display of maximum discharged capa-
city; the status indicator 'R' flashes
Display of completed charge cycles;
the status indicator 'R' flashes
Date display; the status indicator 'R'
flashes
Display of momentary charge current (not stored
in the BID chip). This can be altered using the
'SET' buttons. The cursor and status indicator 'R'
flash
Display of momentary discharge current (not sto-
red in the BID chip). This can be altered using the
'SET' buttons. The cursor and status indicator 'R'
flash
Battery type display; the cursor and
status indicator 'R' flash
Order No.
8467