Introduction; Packaged Parts; Dimensions Of Parts - NEC NP01TK Manual De Instalación Y Ajuste

Introduction

■ Packaged Parts

Check that the parts below are included in the package.
Slide arm: 1 set
U-shaped bracket: 1 set
Table securing bracket: 1 unit
Bracket for securing the mounting unit
for table projection to the table.

■ Dimensions of Parts

The drawings show the external view of the mounting unit for table projection, the movement range when mounting the projector, the sliding range of
the table clamp knob and the floor securing bolt hole dimensions. *The mounting dimensions shown are for a projector set to project downwards.
Unit: mm
Projector / unit center
(sliding range)
60
107
(maximum slide)
Cable cover
F.L.
Table clamp knob
56
Projector mounting screws (M4 × 10 mm): 4 units
Special screws for attaching the projector.
Assembly screws (M4 × 15 mm): 10 units
Screws for assembling the slide arm and U-shaped bracket and mount-
ing the table securing bracket.
* The bolts and screws for securing the floor shall be prepared sepa-
rately depending on the installation work.
Installation and adjustment instructions (this manual): 1 copy
Projector mirror center
75
ENG-3
396
264
U-shaped bracket / table securing bracket
4- 6.4
368
Hole position and dimension drawing for floor
securing bolts