eufy Security SpaceView Pro Manual Del Usuario página 5

4
ADDING
A NEW BABY CAMERA
The baby camera and baby monitor are paired and ready to use right out of the box. Refer to the
following steps when adding extra baby cameras or after resetting a baby camera.
1. Enter menu settings, go to Camera -> Add Camera, then follow the onscreen instructions
to start the pairing.
c
23 o
4
Add Camera
Delete Camera
Cycle Cameras
Camera Settings
2. Press and hold the pairing button on the rear of the camera for 1 second until a notification
prompt is heard.
3. Check the firmware version of the monitor (see image below) to make sure your baby
monitor and camera are running the same, latest firmware version.
Night Vision Mode
Time Set
Sleep Mode
Anti-Screen Flicker
Language
Default Settings
Temperature Unit
Connect with Us
To check whether it is the latest version:
Visit the website below:https:/ /www.eufylife.com/support/5505/spaceview-baby-monitor
1
05 EN
06 12 AM :
60
Secs
Scanning for new camera
1Secs
Push the button on the
camera to pair.
:
06 12 AM
4
https://www.eufylife.com
United States +1 (800) 988 7973
United Kingdom +44 (0) 1604 936 200
Germany +49 (0) 69 9579 7960
Japan +81 03 4455 7823
support@eufylife.com
Monitor: v x.x.x
Camera: v x.x.x
SN: T8300E0A18370E72
Go to "Firmware Updates" section and check whether your firmware version is the latest
2
version. If not, download the "T8300 SpaceView xxx ''Firmware under the "Firmware
Updates" category. Make sure you download the version in corresponding language.
Follow the steps in the "eufy Security Software Upgrade Guide" video or Firmware Upgrade
3
Manual to complete firmware upgrade.
Note:
• The baby camera can be added to the monitor. Before adding the camera, make sure
the baby camera is running the same, latest version with the monitor's.
• Chrome OS is not supported for firmware upgrade.
• Before you upgrade firmware, use the provided micro USB cable (1m) to connect the
device needed to your computer.
5
USING
THE BABY MONITOR
When two or more cameras are added to the monitor, you can manually switch among cameras
by pressing the monitor's OK button. Once the camera switch is completed, the icon of the
selected camera will appear on the corner of the baby monitor.
You can also select the "Cycle Camera" option. The screen cycles through the list of connected
baby cameras according to the preset intervals.
Note: The monitor will emit a loud noise if placed too close to the camera. This is normal and is
resolved once the camera is moved away from the monitor.
EN 06