Quick Start Guide
• Take the air purifier out of the box and remove the clear, protective plastic bag.
• Place the air purifier on a firm, level surface.
• Make sure the air purifier is off and unplugged to confirm that the filters are firmly in
place and did not become loose during shipping.
Fig. 3
Fig. 5
Note: Unit will not operate unless filters and grill cover are properly installed.
Filter Guide
Pre-Filter: Collects hair, fur, and other larger airborne contaminants and particles. It
should be vacuumed clean every 30 days.
PetPlus Odor Filters: Removes odors associated with pet urine, pet feces, litter, and wet
dog. They should be replaced every 6 months.
True HEPA Filters: Captures and removes up to 99.97% of airborne contaminants. They
should be replaced every 12 months.
All manuals and user guides at all-guides.com
TotalClean
Air Purifier Quick Start and Filter Guide
1. To check filters, open the rear cover by gently pushing
Fig. 1
down on the release tab on the top of the rear grill
cover. (Fig. 1)
2. Open the grill cover outward until the tabs at the bottom
of the grill cover easily slide away from the unit. (Fig. 2)
Fig. 2
3. The True HEPA filters will be resting inside the unit. Make
sure the filters are firmly seated inside of the unit. (Fig. 3)
4. Locate the PetPlus Odor Filters in the rear grill cover.
Remove the PetPlus filters from the plastic bags they
are shipped in and set aside. Check to make sure the
Fig. 4
Pre-Filter is seated in place on the frame of the grill
cover. (Fig. 4) Then place the PetPlus Odor Filters back
into the grill cover, seating them on the rails, with the pull
tabs facing outward at the top of each filter. (Fig. 5)
5. Place the tabs at the bottom of the grill cover into the
base of the unit. Gently push the grill cover back into
Fig. 6
place until you hear a click sound indicating that the grill
cover is firmly latched. (Fig. 6
Connect the power cord into a standard AC outlet.
)
QS-ATPET02