TECshow NAVIGATOR 3+ Manual De Usuario página 13

This indicates you that you are now in the Audio
trigger mode.
2. Press the Chase # button, 1-12, that you want
to playback. The selected Chase LED should
illuminate and engage. The selected chase will
16. BANK COPY & FIXTURE COPY
Bank Copy
1. Enter the Program mode.
2. Use the Bank UP/DOWN buttons to select the
bank to be copied.
3. Tap the Midi/Rec button, and then use the Bank
UP/DOWN buttons to select the bank that you
want to copy to.
4. Tap the Music/Rec button. All LED´s will flash three
times to confirm your bank copy operation.
17. FADE TIME
1. Press and hold down the MODE button, then
tap the Tap/Disp button. The LED display will
display "ONLY" or "ALL", for 3 seconds, depend-
ing on the current setting. "ONLY" indicates that
the Pan/Tilt channels will only be affected by
the fade time fader while "ALL" indicates that all
channels will be affected by the fade time fader.
2. To change this setting, tap the Tap/Disp button
while pressing and holding down the Mode but-
ton. Doing so, should switch between the only
and ALL options.
trigger to sound via the internal microphone
or to audio via the line level input if connected.
Pressing the Music/Rec button again will disen-
gage audio mode.
Fixture Copy
1. Enter the Program mode.
2. Press the Fixture # button, 1-12, that you wish
to copy.
3. Using channel faders 1-8 or joystick, set your
look for the light.
4. Press and hold down the same Fixture button,
then tap the Fixture # button that you want to
copy the same settings to.
P. 13
| Tecshow Navigator 3+
English version