TECshow NAVIGATOR 3+ Manual De Usuario página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. EDITING SCENES
1. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the
indicator is flashing, record mode is engaged
and you may release the Program button.
2. Using the UP/Down BANK button, select the
bank that contains the scene that you want
to edit. You can view the active bank in the
LED-display.
3. Press the Scene button, 1-8 , that you want to
edit so the scene comes on.
4. Select the fixture or fixtures that you wish to
9. COPY A SCENE
1.
Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the
indicator is flashing, record mode is engaged
and you may release the Program button.
2. Select the bank that contains the scene you
want to copy with the Bank UP/DOWN buttons.
3. Select the Scene # button, 1-8, that you want to
copy.
4. Use the UP/DOWN BANK buttons to change the
scene bank if desired.
5. Press the Midi/Rec button followed by the
Scene # button, 1-8, that you want to copy the
scene to. All LED´s should flash three times to
confirm and save settings.
6. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display stops flashing. A
flashing Blackout indicator, in the LED display,
is indicative that you are out of the program
mode.
P. 8
Tecshow Navigator 3+ | English version
change settings for in the current scene by
pressing the relevant Fixture #, 1-12. The select-
ed fixture LED´s should illuminate.
5. Make your changes using the faders or joystick.
6. Press the MIDI/RED button and the press the
scene # button that you are editing. All LED´s
will flash three times to confirm that your new
settings were saved.
7. Press and hold down the Program button for
approximately 2 seconds to exit. A flashing
Blackout indicator, in the LED display, is indica-
tive that you are out of program mode.

Publicidad

Tabla de contenido
loading

Tabla de contenido