CTEK PRO25S Manual Del Usuario página 7

OPERATING
INSTRUCTIONS
1. Connect the charger to the battery.
For batteries mounted inside
a vehicle
1. Connect the charger according to
the vehicles manual.
2. Connect the charger to the wall
1 2
socket.
3. Disconnect the charger from the
wall socket before disconnecting
the battery.
4. Disconnect the black clamp
before the red clamp.
2. Connect the charger to the wall socket. The power lamp
will indicate that the mains cable is connected to the wall
socket. The error lamp will indicate if the battery clamps
are incorrectly connected. The reverse polarity protec-
tion will ensure that the battery or charger will not be
damaged.
3. Press the MODE-button to select charging program.
4. Follow the indication lamps through the charging process.
The battery is ready to start the engine when
The battery is fully charged when
5. Stop charging at any time by disconnecting the mains
cable from the wall socket.
MODE-
BUTTON
NORMAL BATTERY
is lit.
is lit.
Temperature sensor
The temperature sensor works automatically and
will adjust the voltage to the ambient temperature.
Place the temperature sensor in the positive clamp
or as the close to the battery as possible.
+
–
READY TO USE
CHARGING
EMPTY
ERROR
LAMP
MODE
POWER
NORMAL LITHIUM SUPPLY RECOND
LAMP
PROGRAM
LITHIUM
PROGRAM
FULLY CHARGED
RECOND
PROGRAM
SUPPLY
PROGRAM
EN • 7
PR