General Directions; Technical Specifications - LANDIRENZO STAP00B Manual De Instrucciones

General directions

We advise you to fix the
Timing Advance Processor
in a vertical position, away
from possible
infiltrations and excessive
heat sources (for example:
exhaust manifolds), so as to
avoid to irreparably damage
the Timing
Processor.To avoid bad
workings of the Timing
Advance Processor we
advise you to:
- pass the Timing Advance
Processor wires away from
the high tension wire;
- make good connections
and do not use "steal
current".
Please, pay attention that
the best connection you can
do is a duly insulated welding.
Please advise the client that in case
of damage, the Timing Advance
Processor is provided with an
emergency connector
switches off the same variator and
resets the original connection
operating as follows:
disconnect the Timing Advance
Processor wire and insert the
emergency connector.
Do not absolutely open the Timing
Advance Processor box, especially
when the engine is running or the
board panel is inserted.
Landi Renzo.
responsabilities for damages caused
All manuals and user guides at all-guides.com
water
Advance
which
Declines every
to things or person which derives
from the tampering of its own device
provoked by unauthorized persons.
Stick the adhesive label supplied in
the wrapping, into the engine
compartment in a good position, to
advise of the presence of the Timing
Advance Processor.

Technical Specifications

Feeding T ension
10 ÷ 14 Vdc
Overal dimensions of the Electronic
Advance Variator Box
height
depth
width
Ø fixing hole
Advance regulation
The Timing Advance Processor
STAP 00 B
is a FUEL retarder.
+
Fuel retard register
If you want to correctly regulate the
advance, operate as follows:
- Start the car on GAS mode and
operating on the distributor, regulate
the advance so as to obtain the best
performance on GAS mode;
- Pass to FUEL mode and operating
on the register set beside the Timing
Advance Processor connector, bring
the advance back to the original
value.
GB
120 mm
27 mm
75 mm
6 mm
04