4.
Select the zone number you want to remove:
5.
Click Remove then OK to confirm.
6.
Click Save.
Completing Installation
1.
Re-install the front rubber tamper button if it was removed.
2.
Re-install the front plastic housing and tighten the bottom
screw.
Specifications
Compatibility
xGen control panels
Wireless operating
433.65 MHz
frequency
Maximum power output
1 dBm
Required Power
12.0 VDC (provided by panel)
Current Draw
50 mA maximum
Supported Wireless
433-63 All devices, 433-80plus PIR and
Devices
Door Window Switch
Dimensions (H × W × D)
155 mm x 95 mm x 68 mm
0° to 49°C
Operating temperature
(32° to 120°F)
6 / 54
−34° to 60°C
Storage temperature
(−30° to 120°F)
Relative humidity
up to 90% noncondensing
Regulatory information
Manufacturer
Placed on the market by:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
Warnings and
These products are intended for sale to, and
Disclaimers
installation by, an experienced security
professional. UTC Fire & Security cannot provide
any assurance that any person or entity buying its
products, including any "authorized dealer," is
properly trained or experienced to correctly install
security related products.
For more information on product warnings, refer
to firesecurityproducts.com/policy/product-
warning/ or scan the code.
European Union
UTC Fire & Security hereby declares that this
directives
device is in compliance with the applicable
requirements and provisions of all applicable rules
and regulations, including but not limited to the
Directive 2014/53/EU. For more information see:
www.utcfssecurityproducts.eu
2012/19/EU (WEEE directive): Products marked
with this symbol cannot be disposed of as
unsorted municipal waste in the European Union.
For proper recycling, return this product to your
local supplier upon the purchase of equivalent
new equipment, or dispose of it at designated
collection points. For more information see:
www.utcfssecurityproducts.eu/recycle/
Contact information
www.utcfireandsecurity.com or www.interlogix.com
Customer support
For customer support, see www.utcfssecurityproducts.eu
EL: Οδηγίες Εγκατάστασης
Σύνοψη προϊόντος
Το NXG-433 επιτρέπει την προσθήκη ασύρματων συσκευών
σε ένα σύστημα xGen. Οι συσκευές αυτές περιλαμβάνουν
ασύρματους πομπούς με ενσωματωμένη επαφή, ασύρματους
αισθητήρες κίνησης, εισόδους γενικής χρήσης και μπρελόκ. Το
μοντέλο πίνακα ελέγχου xGen που χρησιμοποιείτε θα
καθορίσει τον αριθμό τω ασύρματων ζωνών και μπρελόκ που
μπορούν να προστεθούν.
Ο δέκτης είναι ένα αυτοτελές πλαστικό περίβλημα και
συνδέεται με έναν πίνακα ελέγχου xGen μέσω του τυπικού
διαύλου 4 καλωδίων.
P/N 466-2948 • REV A • ISS 14DEC17