Before Using For The First Time - Bosch GL-40 Instrucciones De Uso

en
Used vacuum cleaners
Used vacuum cleaners still contain many valuable
materials. Therefore, please take your used vacuum
cleaner to your retailer or recycling centre to be
recycled. For current disposal methods, please
enquire at your retailer or your local council.
Disposal of filters and dust bags
Filters and dust bags are made from environmentally
friendly materials.
As long as they do not contain substances that are
not permitted to be disposed of in the household
rubbish, you can dispose of them with your normal
household rubbish.
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
Fold out the picture pages.

Before using for the first time

1*
Figure
Push the handle onto the flexible hose until it
engages.
2*
Figure
Push the crevice nozzle and upholstery nozzle into
the accessories holder as illustrated.
Setting up
3
Figure
a)Push the flexible hose adapter into the air intake
opening in the vacuum cleaner lid until it engages.
b)To remove the flexible hose, press the two lugs
together and pull the tube out.
4*
Figure
a)Connect together the handle and the fixed/telescop-
ic tube.
b)Push the handle into the telescopic tube until it
engages.
Press on the locking collar and pull out the telescop-
ic tube to disconnect.
10
All manuals and user guides at all-guides.com
Figure
a) Insert the fixed tube into the floor tool adapter.
b)Push the telescopic tube straight into the connect-
Figure
a)Connect the fixed tubes together.
b)Release the telescopic tube by moving the adjusting
Figure
Figure
Controlling the suction level
Figure
Vacuuming
Figure
* Dependent on model
5*
ing piece of the floor tool until it engages.
Press on the locking collar and pull out the telescop-
ic tube to disconnect.
6*
sleeve/sliding switch in the direction of the arrow
and adjust the tube to the required length.
7
Holding the power cord by the plug, pull out the
required length and plug the plug into the mains
socket.
8
Switching on/off
Your appliance is fitted with a pop-out control but-
ton.
To switch on the appliance, press the control button
in the direction of the arrow down to the stop and
release. This will release and extend the control.
The blue indicator in the filter status area lights up,
indicating that the appliance is ready for use.
To switch off the appliance, press the control button
in again down to the stop. This will leave the control
button retracted into the appliance. The blue indica-
tor goes out.
9
The required suction level can be set to the level
required by turning the control knob in the direction
of the arrow.
Low suction range
For vacuuming delicate fabrics,
e.g. curtains.
Medium suction range
For daily vacuuming of lightly
soiled floors.
High suction range
For vacuuming durable floor
coverings, hard floors and for
heavily soiled surfaces.
10
Adjusting the floor tool:
Rugs and carpets
Hard floors
=>
=>
=>
=>
=>