Storage When Not In Use - Silvercrest SHSD 2600 A1 Manual De Instrucciones

SilverCrest SHSD 2600 A1
regular basis (approx. once a month). Use a non-toxic limescale remover designed for coffee
machines and other household devices (e.g. based on citric acid).
1. Open the lid (7).
2. Fill the hot water dispenser with warm drinkable water until at least the "0.5L MIN" mark.
3. Add the required quantity of limescale remover to the water reservoir (9). Follow the
instructions for the limescale remover.
5. Close the lid (7).
6. Plug the power cable (10) into an easily accessible mains socket.
7. Place a large mug (with a capacity of at least 250 ml) centrally on the holder filter (13).
8. Press the unlock button (6) for at least 3 seconds to unlock the device. A beep sounds and the
temperature (1) and volume display (2) flash. At the same time, the water temperature (5) and
water volume (4) buttons light up.
9. If necessary, press the water temperature button (5) repeatedly to select the value "85".
9. If necessary, press the water volume button (4) repeatedly to select the value "200".
10. Press the start button (3) to produce the set volume of hot water. The container placed on the
holder filter (13) is then lit up and filled with water.
11. Pour away the water dispensed.
12. Repeat steps 8 to 11 until there is no more water in the water reservoir (9).
13. Remove the water reservoir (9) and rinse it with clean water. Put the water reservoir (9) back
on the device.
14. Fill the hot water dispenser with drinking water until at least the "1.5L" mark.
15. Close the lid (7).
16. Press the unlock button (6) for at least 3 seconds to unlock the device. A beep sounds and the
temperature (1) and volume display (2) flash. At the same time, the water temperature (5) and
water volume (4) buttons light up.
17. If necessary, press the water temperature button (5) repeatedly to select the value "rt".
18. If necessary, press the water volume button (4) repeatedly to select the value "200".
19. Press the start button (3) to produce the set volume of hot water. The container placed on the
holder filter (13) is then lit up and filled with water.
20. Pour away the water dispensed.
21. Repeat steps 16 to 20 until there is no more water in the water reservoir (9). The hot water
dispenser is then clean and descaled.

8.3 Storage when not in use

If the hot water dispenser is not to be used for an extended period, store it in a clean and dry
place.
1. Unplug the power cable plug from the wall socket.
2. Allow the hot water dispenser to cool completely before storing it.
40 - English