Using Cd Effects - Tascam CD-BT1MKII El Manual Del Propietario

Using CD effects

(continued from the previous page)
CAUTION
If you set the key control to O
tuning value is greater than 0, the fine tuning
value is automatically reset to 0. Similarly, if
you set the key control to I 6 while the fine
tuning value is less than 0, the fine tuning
value is automatically reset to 0.
Also note that when key control or VSA is
ON, you may find that the music played back
has a "vibrato" feel. This is not a fault of the
CD player – it is a natural result of the special
effects.
Using CD effects
Turning CD effects on and off
Pressing the CD EFF switch at the side
of the CD-BT1MKII turns on the pre-
set CD effects: BEE (Bass Enhancement
Effect), mono monitor, split monitor.
These three CD effect components can
be used simultaneously. The
bol is shown on the display. Press the
CD EFF switch again to turn off the
CD effects.
BEE (Bass Enhancement Effect)
BEE reduces or enhances the bass com-
18
— TASCAM CD-BT1MKII
All manuals and user guides at all-guides.com
ponent of the CD playback.
Press and hold the
key to enter the CD Effect menu. Press
6 while the fine
either the
. Press either the
BEE
to select from the choices listed below:
 : normal playback (the sound is
OFF
not affected in any way)
 : the bass component of the
BST
sound will be boosted
 : the bass component of the
ENH
sound will be boosted and the
definition of the bass part of the
music will be enhanced
 : bass component of the sound
CUT
will be cut out
Mono monitor
Setting the monitor mode allows you
to control the output signal between
mono and stereo with alternate options
sym-
CD EFF
for both.
Press and hold the
EFF key to enter the CD Effect menu,
and select
PREV or
UP or DOWN
following:
TMP/KEY / CD EFF
or key to choose
PREV NEXT
UP or DOWN
TMP/KEY / CD
by pressing either the
MONO
NEXT key. Press either the
key to select from the
 : outputs a mono signal, mix-
L+R
ing the L (left) and R (right) chan-
nels.
 : outputs the L channel signal
L
only.
key
 : outputs the R channel signal
R
only.
 : outputs normal stereo signal.
OFF
Split monitor
Setting the split monitor mode allows
you to split the CD output and the bass
guitar into left and right outputs.
Press and hold the
key to enter the CD Effect menu, and
select by pressing either the
SPLT
or NEXT key. Press the
key to select from the following:
 : outputs the sound of the CD
C-B
from the left, and the sound of the
bass guitar from the right.
 : outputs the sound of the bass
B-C
guitar from the left, and the CD
sound from the right.
 : outputs stereo mixed sound of
OFF
CD and bass guitar from left and
right.
TMP/KEY / CD EFF
PREV
UP or DOWN