Front And Rear Panel Layout; Speaker Output; Status Led - Monitor Audio IA40-3 Manual Del Propietário

Front and Rear Panel Layout

1
7
1. Power Input
Connect the supplied power supply output
lead here. Use ONLY the appropriate IEC
mains lead and power supply provided with
the product.
2. External IR
Connect the supplied IR Receiver. This is used
for learning remote codes and to control the
amplifier. A remote must be paired in order to
enable Bluetooth searching.
3. Sub/ Line Out
Line level output for connecting to an active or
another mono device.
4. RS232
For use with home automation systems
and uses a block connector for the wiring
configuration and set up protocol.
5.

Speaker Output

Accepts up to 12 gauge cable for connecting
speakers.
6. Antenna
Comes unattached from the unit and should
be connected to the IA40-3 for Bluetooth.
To fit the antennae simply tighten it onto the
threaded input on the amplifier.
2 2
2 3
8
IA40-3 Manual IA40-3 Manual
4 5
9
7. EQ and Input Dip Switches
Two position switches for selecting between
options listed above and below the switches.
8. Optical Input
Used to connect digital optical audio source to
the IA40-3 using a SPDIF connector.
9. Analogue Input
Used to connect an analogue stereo audio
source to the IA40-3 using a 3.5mm stereo
mini jack connector.

10. Status LED

Will light up different colours static or flashing
to indicate different operations, refer to the
next page for more information.
11. Multi-Function Encoder
Controls volume up and down via rotation,
power control and configuration as well as
Bluetooth and Remote pairing.
10
6
11