Care And Maintenance; Troubleshooting - allen+roth FP1B4213CP Manual De Instrucciones

CARE AND MAINTENANCE

• Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as
these will dull the finish and void your warranty.

TROUBLESHOOTING

PROBLEM
Leak from under handle.
Leaks from the hose under the
deck.
Low water pressure
The hose does not retract.
WARRANTY
The manufacturer warrants this faucet to be free from defects in workmanship and material present
at time of shipment from the factory for a limited lifetime from the date of purchase. This warranty
applies only to the original purchaser. The manufacturer agrees to correct such defects at no charge
or, at our option, replace the faucet with a comparable or superior model. To obtain warranty service,
call our customer service department at 1-866-439-9800 for return authorization and shipping
instructions. You may be required to present a copy of your sales receipt as proof of purchase. All
cost of removal and reinstallation are the expressed responsibility of the purchaser. Any damage to
the faucet by accident, misuse or improper installation, or by affixing accessories not produced by
the manufacturer, are the purchaser's responsibility. The manufacturer assumes no responsibility
whatsoever for faucet installation during the warranty period. There is no further expressed warranty.
The manufacturer disclaims any and all implied warranties. The manufacturer shall not be liable
for incidental, consequential or special damages arising at or in connection with product use or
performance except as may otherwise be accorded by law. This warranty gives you specific legal
rights, and you may also have other rights which vary from state to state, province to province. This
warranty supersedes all prior warranties.
POSSIBLE CAUSE
Trim cap has come loose.
O-ring on cartridge is dirty or
damaged.
Hose and spray head
connection may be loose.
Quick connector is clogged
with debris.
The weight is not installed in
the appropriate position.
9
CORRECTIVE ACTION
Tighten the trim cap. Clean or
replace O-ring.
Tighten the connection between
the spray head and hose.
Turn off water supply and
disconnect the quick connector
from the discharge tube. Unscrew
the quick connector from the
hose and clean under running
water. Screw back onto hose and
connect back to discharge tube.
Test water flow. If water pressure
is still low then replace the quick
connector.
Reinstall or readjust the weight.