Care And Cleaning; Troubleshooting - allen+roth 73-BRT2-BN-AR Manual De Instrucciones

INSTALLATION INSTRUCTIONS (continued)
11.
After installation is complete, turn on the water supply and allow both hot and
cold water to run for at least one minute to flush away any debris that could
cause damage to internal parts. While the water is running, check for leaks. If
leaks occur, gently tighten the nut on the connection that is leaking. Turn off
the water.

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish
and void your warranty.

TROUBLESHOOTING

PROBLEM
Faucet leaks underneath
handle.
Water does not completely
shut off.
POSSIBLE CAUSE
Bonnet has come loose or O-ring on cartridge is
dirty or twisted.
Rubber valve seat is dirty, stuck, or broken.
1. Move the handle to the OFF position. Unscrew
the handle screw and remove the handle.
2. Tighten the bonnet by turning it clockwise. Move
the cartridge stem to the ON position. The leak
should stop draining out from around the
cartridge stem.
3. If the leak does not stop, shut off the water supply.
Remove the bonnet by turning it counterclock-
wise. Lift out the cartridge valve. Inspect the
larger O-ring on the cartridge bonnet and the
smaller O-ring on the cartridge stem. Remove
any debris from the O-rings. If either O-ring is
twisted, straighten it. If either O-ring is damaged,
replace the cartridge by calling customer
service.
4. Position the cartridge back into the faucet body.
Make sure the ridges on the two sides of the
cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet
onto the faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Remove the handle from the faucet body. Loosen
the bonnet by turning it counterclockwise. Lift
out the cartridge assembly.
3. Inspect the rubber valve seat in the faucet body.
If there is debris or brass scrap on the surface
of the seat, remove it. If the rubber seat is stuck
tightly in the water inlet hole, push it gently with
a fingertip so it moves up and down smoothly.
The spring (smaller end up) must be placed
back underneath the valve seat. If the rubber
valve seat is worn out or broken, replace the
cartridge by calling customer service.
4. Position the cartridge back into the faucet body.
Make sure the ridges on the two sides of the
cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet
onto the faucet body.
5. Reinstall the handle.
6
11
SOLUTION