General Operation - AEG BSS 4822 Instrucciones De Servicio

English
26
CAUTION:
• Do not operate the device on maximum volume. This
can cause damage.
• Do not touch the speaker membranes with fingers or
objects. This will cause damage to the membranes.
• Do not stick any objects into the bass-reflex opening
on the right side of the subwoofer.
First Use of the Device/Introduction
• Select a proper place for the device. A dry, level and slip
proof surface is suitable.
• Make sure the device is vented sufficiently!
• Remove the protective film from the device, if present.
Connecting the loudspeakers
Connect both loudspeakers to the SPEAKER jacks (7).
Power supply
• Insert the grid plug into a properly installed socket.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.

General Operation

Switch device on/off
• Turn on the device by setting the power switch (9) to the
"ON" position.
• To switch off the device, set the power switch POWER
on the rear to the "OFF" position. To disconnect the unit
completely from the mains, pull the mains plug from the
socket.
NOTE:
After about 15 minutes without signal, the device will auto-
matically switch to standby. To reuse the device, press the
/MODE button.
/MODE button (1)
CAUTION:
Ensure that the volume is set to minimum. If the device is
turned on with the /MODE button, a beep will be heard.
• Press the /MODE button. The color of the control lamp
(3) will change depending on the operating mode:
Blue = Bluetooth
Red = AUX
Weak red = Standby
• Press the /MODE button for ca. 2 seconds to switch to
standby.
Volume
To change the volume on the device, turn the VOL+/VOL-
control (4).
BASS control (5)
Use the control to adjust the intensity of the basses.
Sound Settings
If necessary, change the EQ setting in your playback unit to
create the best sound.
Playing back music files
You have two possibilities to play back your own music files
with the device: via cable connection or wireless via Blue-
tooth.
By cable (Cable not included in the scope of delivery)
1. Connect the external device with a cinch cable (2x RCA)
to the AUX IN R/L jacks on the rear of the device. If neces-
sary, use a suitable adapter (not included in the scope of
delivery.
2. Repeatedly press the /MODE button (2) until the con-
trol lamp (3) lights up red.
3. Start the playback of your audio source. Listen to the
sound playback via the speaker.
4. For the further procedure, please refer to the user manual
of the external audio source.
NOTE:
If possible, adjust the volume of the external unit to a com-
fortable level.
Cordless via Bluetooth
Bluetooth involves a technology for wireless radio connec-
tion of devices over a short distance. Devices with Bluetooth
standard are transmitting between 2.402 and 2.480 GHz in
the ISM band (Industrial, Scientific and Medical). Interference
can be caused for example by WLAN-networks, DAB radios,
cordless phones, or microwave ovens which work on the
same frequency band.
This device offers you the possibility to use a Bluetooth-
enabled device. The functional radius is limited to approx.
15 metres depending on the surroundings and the unit used.
If your playing device supports the A2DP profile (Advanced
Audio Distribution Profile) and has a music-player function,
then you can also wirelessly transfer music to the device. The
A2DP profile involves a multivendor Bluetooth profile. By
streaming, stereo-audio signals are wirelessly transferred be-
tween the playing device (source) and the receiving device.
Due to the different device manufacturers, models, and
software versions, a full functionality cannot be guaranteed.