Cub Cadet 45-03293-100 Manual Del Usuario página 5

7. Assemble a spacer (I), a 3/4" flat washer (G), a wheel
(air valve facing out) and another 3/4" flat washer (G)
onto the end of the axle that has both the large and
small holes. See figure 4.
8. Install a 1/8" x 1-1/2" cotter pin (E) into the small hole
in the end of the axle. See figure 4.
9. Open the bail on the drive pin (J) and install it through
the wheel and the large hole in the axle. Close the bail
to lock the pin in place. See figure 4.
(V) DRIVE PIN
(M) 1/8" x 1-1/2"
COTTER PIN
AIR VALVE
(K) 3/4" FLAT
WASHER
FIGURE 4
10. Hook the double bent end of the flow control rod through
the hole in the slide gate bracket located near the bottom
of the hopper. See figure 5.
FIGURE 5
ENGLISH
(P) SPACER
11. Turn the spreader upright on its wheels.
12. Assemble the flow control mounting tube to the hitch tube
using two 5/16" x 1-3/4" hex bolts (A) and 5/16" nylock
hex nuts (D). DO NOT TIGHTEN YET. See figure 6.
FLOW CONTROL
MOUNTING TUBE
(A) 5/16" x 1-3/4"
HEX BOLT
FIGURE 6
13. Assemble the two INNER hitch braces to the flow control
mounting tube using a 1/4" x 1-3/4" hex bolt (B) and a
1/4" nylock hex nut (C). DO NOT TIGHTEN YET. See
figure 7.
14. TIGHTEN all nuts and bolts assembled up to this point.
Do not collapse the tubes when tightening.
(F) 1/4" NYLOCK
HEX NUT
HITCH BRACE
INNER
FLOW CONTROL
MOUNTING TUBE
FIGURE 7
5
(G) 5/16" NYLOCK
HEX NUT
(B) 1/4" x 1-3/4"
HEX BOLT
HITCH BRACE
INNER