Setting instructions
The Twin Sat TV channel unit is adjusted via the control unit of the base module carrier UFG 308 or UFG 312.
Required software version of the control unit: at least 7.00
Required software version ot the control unit from version C00 on: at least 8.01
For adjustment, it is necessary to connect the control unit to the module (consists of channel unit twin A and twin B).
The following listed keys are on to the control unit (also refer to operating instructions for the base module carriers UFG
308, UFG 312).
Note: The settings and values shown are just examples and do not necessarily coincide with the delivery status
of the unit.
The desired parameter is selected with the " " and " " keys.
The selected parameter flashes in the display.
The setting is carried out with the "+" or "-" key.
After all parameters have been set, the setting is saved in the module with the M key. When disconnecting the control
unit from the module without having saved the setting, the settings which had been saved before, become active again.
1. Selecting the channel unit twin A or twin B
The display always refers to one of the two channel units integrated in the module (A or B).
The channel unit in which the settings are to be carried out is called up first.
Note:
The channel unit with the lower output frequency is twin A.
Twin A is competent for setting the output frequency and the output level.
Twin
A
Outp.
Ch12
Stereo
Vol 3
Vid 2
2. Configuration of the channel units twin A and twin B
Selection of input connector A or B for channel unit twin B and switch-off of a channel unit is effected in the submenu
for channel unit selection. For this purpose, enter the submenu by pressing the
Twin
A
Outp.
Ch12
Stereo
Vol 3
Vid 2
Main menu
Twin
B
Outp.
Ch13
Stereo
Vol 3
Vid 2
Main menu
All manuals and user guides at all-guides.com
"Twin A" or "Twin B" is selected with the >> or << key.
1744 MHz
224.25 MHz
7.02/7.20 MHz
AV
1744 MHz
224.25 MHz
7.02/7.20 MHz
AV
1744 MHz
232.25 MHz
7.02/7.20 MHz
AV
key.
***
UFO 340
Input
Input A/B
Output
Twin A
< Return:
Submenu output
***
UFO 340
Input
Twin A/B
Output
Twin B
< Return:
Submenu output
***
A/A
On
Submenu.. >
***
A/A
On
Submenu.. >