Steam Ironing - Crena CY658 Manual De Instrucciones

6-When it is cool down, proceed carefully to refill the tank as
described in paragraph "Instruction for use" in the
instruction. Never refill the water tank if the machine is not
cool down completely.
INSTRUCTION FOR USE
PREPARATION
·Unscrew the safety cap and fill the boiler with water using
the special filter funnel. Make sure that water does not
overflow.
·Retighten the cap fully and carefully. Make sure the safety
cap is fully tighten, otherwise, steam may come back when
boiler is switch on.
·Connect the power supply cable into an earthed power
supply of the correct voltage.
·Switch on the steam station by pressing the switch.
Note: during the filling operation, be carefully that the
water does not overflow as it may come out and wet
the surface where the steam iron is laid.

STEAM IRONING

·Set the iron temperature to the "COTTON-LINEN" steam
position, by turning the knob. All types of fabric can be
ironed at this temperature.
·Wait for the steam ready light goes on and the pilot light
goes off. Push button on the iron to release bursts of steam
from steam holes on the soleplate.
·Use the "Steam Holding System" for keeping the steam
burst continuously without the finger pressure. Release the
button to stop the steam, and when the steam ready light
goes off.
Note: during initial operation of the iron, a few drops
of water mixed with steam may come out of the
soleplate until the temperature stabilizes. It is
advisable to direct the first jet of steam onto another
cloth until a uniform stable jet of steam is obtained.